Front view of the inside of the controller/charger case. The controller, and all high voltage external connections are located on the left side; while the charging systems are on the right. The two logic cards separate the systems, controller card to the front, and charging card to the rear

This shows a set of zener diodes added to the IBGT control wiring. This is a GE recommended retrofit to the original system, which was known to be less then dependable.

The rear left corner of the controller, with the lower left, the KR relay in the middle, and the rear of the logic card to the right.

This shot shows the internal components of the PC Block.

This view shows the controller logic card, removed, and upside down to its mounted position.

A closeup of the top connections of the TS designated controller card.

The controllers triple IGBT setup

Charger ID tag, displaying the "Nife Ver 3" charging software designation.